Daiwa 17 Metallia Magochi 215 (Baitcasting 2 Piece)

Total length: 2.15m /Joint: 2 /Closed length: 111cm /Weight: 85g /Tip diameter: 2.3mm /Bottom diameter: 9.9g /Weight load: #10-#20 /Compatible clamp size: SSS /Carbon content: 84% /Accessories: Chloroprene rod belt, rod bag

Completely capture the maggochi with the high sensitivity that resonates in your hands, which is unique to metal tops. Pursuing the high sensitivity and good bite that are unique to metal. While clearly conveying the sharp and slight hit, it has the flexibility to bite into the maggochi without causing any discomfort. Furthermore, by reducing twisting with the "X45" structure, it has high operability that allows you to manipulate the device as you want, and has a tenacity that can compete with large magochis. It enables a thrilling game where you lure the bait based on a small hit, and with an offensive tone design that allows for a sharp and powerful wake, it completely captures the maggochi, which is said to be difficult to maneuver until it bites firmly and hooks. DAIWA TECHNOLOGY... Spike tip AGS (air guide system), Metal top, X45, Air sensor sheet (standard trigger) Precautions when using metal top About temperature changes in metal top. Due to the characteristics of the material, superelastic titanium alloy loses its elasticity in a low temperature environment of 5 degrees or less, causing the tip to return slowly. Extremely cold weather or wind in the early morning or at night may cause noticeable bending. Furthermore, in an environment of 0 degrees or less, the elasticity decreases more and more, and the tip of the tip remains bent and does not return. In either case, when the temperature rises, the material returns to its original superelasticity and can be used normally. Please avoid using it in a way that causes excessive bending. Metal tops are comfortable to use during normal operations, but excessive bending due to external factors such as winding up or thread tangles at the tip may leave curls (plastic deformation) or cause damage due to metal fatigue. there is. In the unlikely event of a problem, you can correct it by hand. If there are any kinks like in 2, you can correct them by slowly bending them in the opposite direction to the curved side. However, if you repeatedly correct the quirks, it may cause metal fatigue, so please avoid operations that will leave the quirks, such as getting caught. Please be sure to read the instruction manual for comfortable use.